14-03-2024, 11:09 PM
(14-03-2024, 09:24 PM)Old Dave Wrote: The other problem (?) I have also seen alluded to elsewhere - that is the spring pin being forced back outwards when the cotter is fully pressed home. This forces the spring pin back about 3/32" so the large stop on the pin is not against the hub fitting. Should this be corrected or do I live with it?
Do the cognoscenti use proper bearings OR sealed ones?
This seems to be a feature of the reproduction pins that are available now. It doesn't seem to affect their longevity, just make sure there's plenty of grease around the area.
I think the bearing choice is a personal one, sealed bearings may give you better oil tightness but can dry out in time, whereas open bearings are easy to lubricate and re-lubricate and re-lubricate.