07-03-2024, 09:01 AM
Hi Bluebird
I had this problem when looking for a float bowl for my updraft set up on the Brookfields special. I needed to change the float bowl angle and drop its level. I cut off the stem of the float bowl, tapped the hole and fitted a brass/copper tube between the float bowl and a spacer on the fuel intake.
Be aware that altering the angle of the float bowl alters the level of fuel at the jet (the jet/choke tube is not immediately above the fuel intake. If you are just moving between 30 degrees and horizontal this will probably not matter much but check the jet level at the jet itself rather than assuming the float level is OK.
Hope this helps
Howard
IMG_3996.jpeg (Size: 130.55 KB / Downloads: 189)
I had this problem when looking for a float bowl for my updraft set up on the Brookfields special. I needed to change the float bowl angle and drop its level. I cut off the stem of the float bowl, tapped the hole and fitted a brass/copper tube between the float bowl and a spacer on the fuel intake.
Be aware that altering the angle of the float bowl alters the level of fuel at the jet (the jet/choke tube is not immediately above the fuel intake. If you are just moving between 30 degrees and horizontal this will probably not matter much but check the jet level at the jet itself rather than assuming the float level is OK.
Hope this helps
Howard
IMG_3996.jpeg (Size: 130.55 KB / Downloads: 189)