Joined: Aug 2017 Posts: 66 Threads: 17
Reputation:
0
I've got the rear hub on the RN back together, with new bearings, seals and brakes, and am in the process of tightening the outer nut (the one on the end of the half-shaft).
The Woodrow book says, "...using a socket and at least 15" leverage, tighten the nut down hard." That's what I'm doing, but I'm worried I'm going to strip a thread.
I've searched the forum for a post about this, but been unable to find one (which seems strange), and wondered if anybody had an actual torque setting.
Joined: Aug 2017 Posts: 926 Threads: 22
Reputation:
10
Location: Near Cambridge, UK
Car type: 1928 tourer (mag type), short chassis Gould Ulster
I have never known a torque setting, but I always use a good fitting spanner, against a thin bit of tube round the hub thread to avoid possibility of damage, and tighten as far as I can, to the extent that I have lifted that corner of the car when doing this. I have never stripped the thread.
Robert Leigh
Joined: Aug 2017 Posts: 3,394 Threads: 106
Reputation:
28
Location: Darkest Bedfordshire
You can heave it up pretty tight. No need to go crazy. The important thing is that the taper should be taking the load not the key.
Joined: Aug 2017 Posts: 741 Threads: 8
Reputation:
11
Location: N W Kent
I always use a 26" breaker bar doing up the halfshaft nuts, haven't stripped a thread as yet.
Joined: Aug 2017 Posts: 773 Threads: 33
Reputation:
16
Location: Beautiful Northumberland
Car type: 1933 RP Saloon (aka Mildred)
Mine were done with an air impact wrench and some loctite. Stripped one thread on an old nut but it came off so easily I think it would have gone with a 6 inch spanner, so was best gone and replaced both to be sure with nice new nuts from cherished supplier
Andy
Enjoy yourself, it's later than you think!
Joined: Aug 2017 Posts: 782 Threads: 26
Reputation:
8
Location: On a hill in Wiltshire
Standard length socket spanner, stand on it.
Gives about (9/12 x your body weight in lbs) foot pounds
In my case around 135 ft lbs, so I give a little bounce to bring it up to 150
Joined: Aug 2017 Posts: 202 Threads: 11
Reputation:
3
I have a chart produced by Camco Solutions Ltd., and their recommendation for the half-shaft nuts was for a torque wrench setting of 125 lbs/ft and that is what I have done my up to.
Joined: Aug 2017 Posts: 2,402 Threads: 33
Reputation:
36
Location: Deepest Frogland 30960
Car type: 1933 RP Standard Saloon
New nuts, new split pins. Tightened with an electric windy gun.
Joined: Aug 2017 Posts: 172 Threads: 1
Reputation:
3
Location: Richmond, Texas, USA
My father used a primitive impact wrench - a stout ring spanner and a hefty hide mallet.
Joined: Aug 2017 Posts: 46 Threads: 2
Reputation:
1
A four foot scaffold pole takes some beating!
J
