The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.30 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Morons
#21
I cannot comment Tony - I don’t use tapered bearings, sorry.
Reply
#22
surely the simple fix is to turn the stub square to fit an off the shelf bearing, or if not possible fit a sleeve so that it is
Reply
#23
Sorry to labour this for no other point than curiosity, but was the welded bearing a proper taper one? When the photos revealed a tapered stub I presumed the welding was to seat a conventional bearing?
Reply
#24
(30-05-2019, 09:26 PM)Hedd_Jones Wrote: surely the simple fix is to turn the stub square to fit an off the shelf bearing, or if not possible fit a sleeve so that it is

You can turn a square?
Blimey Hedd, that must be a clever lathe 

Charles
Reply
#25
lol. A lathe is just a backward horizontal milling machine!

i didnt use the word parallell as I dont think I can spell it
Reply
#26
Hi hedd,

I understand what you are saying, and I've had parts in were this has been done.

But that's just not me.

If it was a special, then that's a different story.

Bob,

After all the cursing over what a previous moron had done, I didn't even check the bearing.

If I remember I'll check tomorrow.

Tony.
Reply
#27
(30-05-2019, 09:53 PM)Hedd_Jones Wrote: lol. A lathe is just a backward horizontal milling machine!

i didnt use the word parallell as I dont think I can spell it

A real engineer makes flat things in a lathe and round things on a milling machine!

Charles
Reply
#28
No, Charles, a real Engineer designs things that he gets a mechanic to make.
Alan Fairless
Reply
#29
(30-05-2019, 09:53 PM)Hedd_Jones Wrote: lol. A lathe is just a backward horizontal milling machine!

i didnt use the word parallell as I dont think I can spell it

Isn't it 'all the l's '

(30-05-2019, 09:26 PM)Hedd_Jones Wrote: surely the simple fix is to turn the stub square to fit an off the shelf bearing, or if not possible fit a sleeve so that it is

Because the early (and sometimes later) stub axles are prone to cracking I would think turning the taper bearing seating to parallel would weaken it further (the stub is somewhat hollowed out as well)
Reply
#30
Tony, all the later ones that Ive had that were cracked did so on the vertical face between the stub and the king pin bearing.

I take your point about thinning the stub, but there are other options. Make a tapered sleeve to push on, perhaps find a suitable bearing with a bigger ID. Or butter it up with weld, normalise and turn.

I could also get one of the minions here to do a FEA analysis. But then I'd have to do some material testing, and work out the loading. That's a ball ache.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)