The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval



Austinsevenfriends › Austin Seven Friends Forum › Forum chat... v
Rivets on handbrake cover

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Rivets on handbrake cover
Erich Offline
Senior Member
****
Joined: Aug 2017 Posts: 690 Threads: 114
Reputation: 2
#1
03-12-2021, 04:31 AM
I'm wondering what the name is of the rivets that hold the handbrake boot cover down? They appear to be a flat head and brass, but the underside has a hole in it like a pop rivet. The head has not hole, so like a solid rivet.

Erich in Mukilteo
Reply
GCD Offline
Junior Member
**
Joined: Jul 2021 Posts: 36 Threads: 7
Reputation: 0
Location: Bath
Car type: 1937 ARR Ruby / 1928 RF (3)
#2
03-12-2021, 11:41 AM
Suggest they may be Bifurcated Rivets
Reply
Nick Lettington Offline
Bodger
*****
Joined: Aug 2017 Posts: 933 Threads: 75
Reputation: 9
Location: Essex
#3
03-12-2021, 12:13 PM (This post was last modified: 03-12-2021, 12:19 PM by Nick Lettington.)
Bifurcated rivets are split in two along the shank. These sound more like the type used for the brake shoes and clutch... and they are called semi-tubular rivets.
Reply
Tony Griffiths Offline
First Grey Mag editor
*****
Joined: May 2018 Posts: 2,981 Threads: 561
Reputation: 22
Location: Peak District, Derbyshire
Car type: 1929 Chummy, 1930 Chummy, 1930 Ulster Replica, 1934 Ruby
#4
03-12-2021, 12:25 PM
Do you have a picture, Eric? Fastenings can go under a variety of names.
http://lathes.co.uk
Reply
Howard Wright Offline
Grey Mag editor
*****
Joined: May 2018 Posts: 2,124 Threads: 111
Reputation: 22
Location: Llandrindod Wells
Car type: 29 Special, 30 RK, 28 C Cab
#5
03-12-2021, 05:47 PM
Hi Erich

I would call them….. “Blind, flat head, hollow copper rivets”. But I’m no expert.

They should be fitted using a roll top rivet punch. However I’ve never managed to get the very expensive set of punches I bought to give a good finish and end up finishing the job with a flat punch.

Cheers

Howard
Reply
Erich Offline
Senior Member
****
Joined: Aug 2017 Posts: 690 Threads: 114
Reputation: 2
#6
04-12-2021, 04:38 PM
Hi All,

Thank you all for the responses. I think Nick has it right. I hsve a tool somewhere that I think will set the back. Being brass, I won't have to use my 3X rivet gun, just a hammer and an anvil.

Erich in Mukilteo
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)