Joined: Sep 2018 Posts: 255 Threads: 67
Reputation:
1
Hi, I know this subject was recently covered, but does anyone know if scaffold boards used as ramps will take the weight of a Nippy up into the back of a transit lwb.
I may buy a car and have the choice of a friends car trailer or hire a van which i would prefer. It's the weight accept on boards that im unsure of. I would of course make sure the boards are strong and sound.
Regards RPM
Joined: Aug 2017 Posts: 1,230 Threads: 33
Reputation:
7
Location: Salop
Car type: '28 GE Cup. '28 AD Chummy '30 RL Saloon. '34 RP Saloon. Too Many toys!
we got a shaper in the back of a transit van using a gate and a winch. two scaffold boards and an austin 7? No problem
Joined: Aug 2017 Posts: 725 Threads: 38
Reputation:
12
Location: Herefordshire
We regularly load cars into the van using scaffold boards reinforced with 3"x 2" on the lower side. On the Transit, there are a couple of conveniently-positioned holes (with rubber blanking plugs) in the lower door cill and I've put a couple of long 10mm coachscrews through the boards to locate positively in these holes.
Joined: Aug 2017 Posts: 3,388 Threads: 105
Reputation:
28
Location: Darkest Bedfordshire
Yes, it's the boards slipping that would worry me. Bolts sound a good idea!
Joined: Sep 2018 Posts: 255 Threads: 67
Reputation:
1
Great!, thanks Guys appears weight wise good, all about securing the boards down first.
Regards RPM
Joined: Aug 2017 Posts: 738 Threads: 13
Reputation:
5
Hi.
I use a pair 9 "x 3" joist planks for my Austin much better grade of timber. Knot Free.
A bit of angle iron on the end to hook over things or holes for pegs.
I have loaded an Mx 5 into a container with them in the past.
