+- Austinsevenfriends (https://www.austinsevenfriends.co.uk/forum)
+-- Forum: Austin Seven Friends Forum (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=1)
+--- Forum: Forum chat... (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=14)
+--- Thread: Valve guide - ok to cut down? (/showthread.php?tid=5254)
Valve guide - ok to cut down? - Tom Coates - 14-11-2020
I am in the process of smoothing out the ports on my block which is quite a nice lockdown job.
I ground down the (late type) valve guides in the intake ports to blend in with the base of the port. Is it ok to do this with the exhaust ports or better left alone?
RE: Valve guide - ok to cut down? - Alan - 14-11-2020
Well, I do.
RE: Valve guide - ok to cut down? - Steve Jones - 14-11-2020
And I do too!
Steve
RE: Valve guide - ok to cut down? - Robert Foreman - 14-11-2020
You could always feather them to your advantage which also gives you maximum guide for valve support.
RE: Valve guide - ok to cut down? - Terrytuned - 14-11-2020
That makes three of us Terry.
RE: Valve guide - ok to cut down? - Zetomagneto - 14-11-2020
Fit them with the top of the guide level with the bottom of the port, that way you still get full support for the valve but no interruption in the port. No need to shorten straight guides.
RE: Valve guide - ok to cut down? - Terrytuned - 15-11-2020
If you push the valve guides down with a high lift cam they will come into contact with the valve spring caps and early guides need to be modified for double springs and high lift cams (see drawing) Terry.
RE: Valve guide - ok to cut down? - Tom Coates - 16-11-2020
(15-11-2020, 01:34 PM)Terrytuned Wrote: If you push the valve guides down with a high lift cam they will come into contact with the valve spring caps and early guides need to be modified for double springs and high lift cams (see drawing) Terry.
Thanks, I didn't want to push the guides down as I was concerned that this could be an issue. I've ground them down flush, not too hard with a die grinder.
RE: Valve guide - ok to cut down? - dickie65 - 16-11-2020
Hi Folks,
My guides are pushed down but still allow full lift then I grind off the bit left in the port.
I can not get the springs out unless until the cam followers are removed. my cam follower guides are also cut down.